hr@vistrainspection.com+91 XXXXX XXXXXMon–Sat 9:00–18:30 · 24×7 shutdown support
Registration FREE for freelancers, clients & collaborators
Vistra Inspection Services and Consultants

Brinell, Rockwell, Vickers or Leeb? Hardness Testing Methods Explained

How the main hardness test methods work, where each is used and what to watch out for when converting hardness values.

2026-10-30 · NDT · Vistra Inspection Services and Consultants

Hardness is one of the quickest ways to check heat treatment, material grade and weld quality. But each method measures hardness differently.

Brinell (HBW)

A tungsten carbide ball is pressed into the surface and the diameter of the impression is measured. It suits castings, forgings and coarse-grained materials because the large impression averages the structure.

Rockwell (HRC, HRB)

Measures the depth of penetration under a major load. It is fast and common for heat-treated steel parts, gears and shafts.

Vickers (HV)

A diamond pyramid makes a small impression. It covers the whole hardness range and is used for weld and HAZ traverses and for thin sections.

Portable Leeb and UCI

Leeb rebound testers measure the rebound speed of an impact body. UCI testers measure frequency shift of a vibrating rod with a Vickers diamond. Both are used on site for large components and welds, but results must be converted, and conversions (ASTM E140) are only approximate for some materials.

Learn all of these in Vistra's two-day hardness testing course.

Need help? Request an inspection quote or register free to connect with inspectors near you.
All 36 States & UTs780 districts covered
Qualified inspectorsASNT / ISO 9712 Level II & III
Reports in 24 hoursPhoto-backed, code-referenced
Secure paymentsUPI · Cards · Net banking
Install the Vistra appFaster access to inspectors & requirements